Mks Gen L Wiring. The 3 wire plug goes on the d11 pin, orientate it in a way that the yellow cable is on the leftmost pin. Web mks gen l fan wiring.
Mks gen l 1.0 wiring: Web our metal bit is, of course, the print bed. Follow edited feb 5, 2021 at 21:37.
Web mks gen_l is a powerful 3d printer control board with atmega2560 and compatible with ramps. Web mks gen l fan wiring. Web our metal bit is, of course, the print bed.
The metioned pins correspond to this schematic. Web mks gen l external drivers and nema23 stepper motors. That would be ok with most control boards (parameters have to be changed in marlin), but the mks gen card’s hardware.
The 3 wire plug goes on the d11 pin, orientate it in a way that the yellow cable is on the leftmost pin. V2.1 version the motherboard integrates spi / uart interface. Web the procedure for the mks gen l 1.0 is also described there.
Web mks gen l board connections; Your config.g should be modified as below. Web mks gen_l is a powerful 3d printer control board with atmega2560 and compatible with ramps.
I already have the board purchased and have been looking at wiring. Mks sgen l v2 wiring/pinouts; V2.1 version the motherboard integrates spi / uart interface and works with.
